Beijing Borui Lianchuang Trading Co., Ltd.

< Product introduction:
German Tiptop
Cold vulcanization adhesive (glue) is recognized as the best multi-purpose cold vulcanization adhesive in the world. Its excellent bonding strength exceeds the German
D
industrial standard and is at the same level as hot vulcanization bonding strength.
Suitable for bonding rubber to rubber, rubber to metal, rubber to fiber, fiber to fiber. It is especially suitable for repairing conveyor belts, cold seamless bonding roller lagging and anti-wear and anti-corrosion rubber linings on various metal surfaces.
< Features:
<
High Quality
Excellent bonding strength exceeds the German Industrial Standard and the same strength as hot vulcanization bonding. (It can surpass the bonding strength of hot vulcanization in conveyor belt repair and cold seamless bonding) Its performance is leading among its global peers.
<
Convenience
Simple tools can be used to operate without the use of large equipment such as vulcanizers.
<
Fast
In case of emergency repair, it can be immediately repaired and used to minimize downtime losses.
<
Reliable
The shelf life is
<
years longer than other similar products.
<
Applicable
The applicable working temperature can reach
℃
It is safe and flame retardant and suitable for both above and below ground use.
Rubber: Use a tungsten steel polishing disc or wire wheel to completely polish it (no shiny surface) and then use a brush to remove dust (do not use water or chemical solvents).
Core body: Grind off the residual glue and then gently grind the fabric (be careful not to damage the fabric layer) to remove the dust (do not use water or chemical solvents). If a thin and even layer of rubber can be retained, the effect of slight polishing of the rubber layer will be better.
Metal: Use a cleaning agent to remove grease from the metal surface, then use a sand wheel or sandblasting to apply a layer of metal surface treatment agent r and let it dry completely.
Mixing: Mix with -r hardener in the proportion of: and mix thoroughly. It must be used up within two hours after mixing, otherwise it will harden and become ineffective.
Apply: Apply a second even thin layer to the combined surface. The surface with an adhesive layer does not need to apply the first layer. The first layer should be completely dry to the point where it no longer sticks to the backs of your fingers. When the second layer dries until it is still slightly sticky (test it with your finger), you can proceed with the final bonding of the surface. (If the second coat is too dry, apply another coat).
Bonding: stick the two sides together to avoid tight fit and compaction.

d_d_ d_d_